[Swan-dev] Two identical networks
Antony Antony
antony at phenome.org
Sun May 22 08:00:31 UTC 2016
dhcp is not required, if you removed ip.
I guess you figured that out and change to kvmsh looks good
my run using two instances went well. Each instance finished in less than 5:00 hours where as one instance would take 9:30 and results are good.
so finally we could run multiple instances. And only one instance we could ssh into. that is fine to me.
-antony
On Sat, May 21, 2016 at 08:37:08PM -0400, Andrew Cagney wrote:
> >> In the past few days I tried similar trick with KVM. There is no IP address on swan112 which seems to work. I just started a testrun with two instances.
> >>
> >> east, west, road.., swan12 ...
> >> east1, west1, road1.., swan112...
> >>
> >> so far it appears to work. I will know more tomorrow.
> >
> > I've the same set up but I'm not seeing traffic, good to know this should work.
>
> And of course, rebuilding everything from scratch fixes what ever my
> issue here was. Traffic now flows across 192.1.2
>
> BTW, what did you do about DHCP vis:
>
> - <ip address='192.9.2.253' netmask='255.255.255.0'>
> - <dhcp>
> - <range start='192.9.2.128' end='192.9.2.196' />
> - </dhcp>
> - </ip>
>
> Andrew
More information about the Swan-dev
mailing list